Kia Sorento: Fuel Line Removal - Fuel Delivery System - Engine Control / Fuel System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Fuel Line Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Line Removal

1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
3.
Disconnect the low pressure fuel quick-connector (A).

4.
Disconnect the vapor hose (A) which is connected from the PCSV.

5.
Lift the vehicle.
6.
Remove the fuel tank.
(Refer to Fuel Delivery System - " Fuel Tank")
7.
Disconnect the vapor tube quick-connector (A).

8.
Open the vapor tube and low fuel line fixing clip to using driver.
9.
Release the under cover (A) after remove the mounting bolts.

10.
Disconnect the fuel & brake line protect (A) from the fixing clip.

11.
Disconnect the fuel line fixing bracket (A) to engine room low.

12.
Remove the fuel line.
Fuel Pressure Regulator Installation
1. Install in the reverse order of removal. ...

Fuel Line Installation
1. Install in the reverse order of removal. ...

See also:

AC Inverter Switch Removal
   • Pry the trim off using a plastic trim tool and apply protective tape around the rela ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A). ...

Front Strut Assembly Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Copyright В© www.ksmanual.com 2014-2023