Kia Sorento: Front Wheel Speed Sensor Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor Removal

1.

Remove the front wheel and tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.

Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.	Remove the front wheel guard .

4.	Remove the front wheel speed sensor cable mounting bolt (A).

5.	Disconnect the front wheel speed sensor connector (B) and then remove the front wheel speed sensor.

6.	Installation is the reverse of removal.

Front Wheel Speed Sensor Components

1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

Rear Wheel Speed Sensor Components

1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

See also:

TJ Joint Inspection
1. Check the spider assembly for roller rotation, wear or corrosion. 2. Check the groove inside the joint case for wear or corrosion ...

Timing Chain Installation
1. Install the balance shaft chain. (Refer to Lubrication system - "Balance Shaft & Oil Pump") 2. Install the crankshaft ...

Engine overheat
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine will probably be too hot. If this happens, you should: 1.Pull off the r ...

Categories

Copyright © www.ksmanual.com 2014-2026