Kia Optima Manuals

Kia Sorento: Radiator Removal and Installation - Cooling System - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Radiator Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Radiator Removal and Installation

1.
Disconnect the battery terminals.
2.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner")
3.
Remove the under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
4.
Loosen the drain plug, and drain the coolant.
Remove the radiator cap to speed draining.
5.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
6.
Remove the radiator upper hose(A) and lower hose(B).

7.
Remove the cooling fan.
(Refer to Cooling System - "Cooling Fan")
8.
Separate the condenser(A) from the radiator(B) and then remove the radiator assembly.

9.
Install in the reverse order of removal.
10.
Fill the radiator with coolant and check for leaks.
  
•
Bleed air from the cooling system.
-
Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.)
-
Turn off engine. Check the coolant level and add coolant if needed. This will allow trapped air to be removed from the cooling system.
-
Put the radiator cap on tightly, then run engine again and check for leaks.
Radiator Components
1. Radiator 2. Radiator lower hose 3. Radiator upper hose 4. Radiator upper air guard 5. Radiator upper mounting bracket 6. Radiator lower mounting insulator ...

Radiator Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Ap ...

See also:

Driver Airbag (DAB) Module and Clock Spring Description
Driver Airbag (DAB) is installed the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by deploying the airbag when frontal crash occurs. The SRS ...

Refrigeration Cycle
...

Front Oil Seal Removal and Installation
1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pullty") 2. Remove the front oil seal(A). ...

Categories

Copyright www.ksmanual.com 2014-2026