Kia Sorento: Front Camera Removal and Installation
| Removal |
| 1. |
Perform the order below with the KDS before removing the front camera.
(S/W Management → Front View Camera → System Identification)
|
| 2. |
Disconnect the battery negative ( - ) terminal.
|
| 3. |
Remove the multi-sensor blanking cover (A).
|
| 4. |
Remove the multi sensor cover (A).
|
| 5. |
Disconnect the front view camera connector (A).
|
| 6. |
Remove the front view camera (A) by pulling both hooks.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
| 2. |
Perform the order below with the KDS when replacing the front view camera.
(S/W Management → Front View Camera → Variant Coding)
|
| 3. |
Enter the specification value read from the existing camera into the new front view camera.
|
| 4. |
Perform the front camera calibration.
(Refer to Front View Camera - "Adjustment")
|
| 5. |
Perform Over The Air (OTA) controller S/W update with KDS.
(Refer to Body Electrical System - "Over The Air (OTA)")
|
Front Camera On Vehicle Inspection
Front Camera Adjustment
See also:
Seat belt restraint system
WARNING
For maximum restraint system protection, the seat belts must always be
used whenever the vehicle is moving.
Seat belts are most effective when seatbacks are in the upright position.
...
SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears.
SS-B Solenoid valve(ON/OFF) is installed at valve body.
...
Direct Electro Hydraulic Actuator Coupling Operation
Electronic Coupling
[Inactive]
[Active]
Operation Order
1.
4WD ECU receives CAN signals from the vehicle's sensors.
...
Manuals list
- Kia Sorento MQ4 2021-2026 Owners Manual
- Kia Sorento XM 2011-2015 Owners Manual
- Kia Sorento XM 2011-2015 Service Manual
