1. |
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
|
2. |
Check the engine oil level.
After engine warm up stop the engine wait 5 minutes then check the oil
level. Oil level should be between the "L" and "F" marks on the dipstick.
If low check for leakage and add oil up to the "F" mark.
|
Selection Of Engine Oil
For best performance and maximum protection of all types of operation,
select only those lubricants which :
|
Output Speed Sensor Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed senso ...
Side Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
IMS Power Seat Control Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the power seat control switch connectors (A).
(Refer to Body - "Front se ...