Kia Optima Manuals

Kia Sorento: Engine And Transmission Assembly Installation - Engine And Transmission Assembly - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Engine And Transmission Assembly Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine And Transmission Assembly Installation

Install the other parts in reverse order of removal.
Perform the following :
•
Adjust a shift cable.
•
Refill engine with engine oil.
•
Refill a transaxle with fluid.
•
Refill power steering fluid.
•
Refill a radiator and a reservoir tank with engine coolant.
•
Place a heater control knob on "HOT" position.
•
Clean battery posts and cable terminals and assemble.
•
Inspect for fuel leakage.
-
After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
-
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
•
Bleed air from the cooling system.
-
Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.)
-
Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.
Engine And Transmission Assembly Removal
   • Use fender covers to avoid damaging painted surfaces. • ...

Timing System
...

See also:

IMS Control Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door") ...

Front Stabilizer Bar Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Component Location
1. Windshield wiper arm & blade 2. Wiper & washer switch 3. Windshield washer hose 4. Windshield wiper motor & linkage 5. Washer motor 6. Washer reservoir ...

Categories

Copyright www.ksmanual.com 2014-2026