Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury.
|
Propeller Shaft Removal and Installation
1.
After making a match mark on the flange yoke and transfer companion,
remove the propeller shaft mounting bolts (A).
Tightening torque:
...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
➀ BSD ...
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Removal and installation of alternator pulley
...