Kia Sorento: Center Side Airbag (CSAB) Removal and Installation - Airbag Module - RestraintKia Sorento: Center Side Airbag (CSAB) Removal and Installation

Kia Sorento (MQ4, 2021-2026) Service Manual / Restraint / Airbag Module / Center Side Airbag (CSAB) Removal and Installation

Removal
1.
Disconnect the battery negative ( - ) terminal.
Note
After disconnecting the battery negative ( - ) terminal, wait at least 3 minutes and 30 seconds.
2.
Remove the front seat back cover.
(Refer to Body - "Front Seat Back Cover")
Note
When replacing the airbag due to deployment of the airbag, replace the seat back assembly.
3.
Remove the center side airbag wiring clips (A).

Restraint — Airbag Module / Center Side Airbag (CSAB) / Removal and Installation / Removal illustration

Restraint — Airbag Module / Center Side Airbag (CSAB) / Removal and Installation / Removal illustration

Information
Clip position :

Restraint — Airbag Module / Center Side Airbag (CSAB) / Removal and Installation / Removal illustration

4.
Remove the center side airbag (A) after removing the nuts.

Tightening torque :
7.0 - 10.0 N·m (0.71 - 1.02 kgf·m, 5.1 - 7.4 lb·ft)

Restraint — Airbag Module / Center Side Airbag (CSAB) / Removal and Installation / Removal illustration

Installation
1.
Install in the reverse order of removal.
Note
Since improper installation of the front seat back cover will prevent the normal deployment of the side airbags, make sure that the front seat back cover is properly installed.
2.
Check that the airbag system operates normally.
Note
When the IG is on, the airbag warning lamp should turns off after turning on for 3 - 6 seconds.
Center Side Airbag (CSAB) On Vehicle Inspection. Center Side Airbag (CSAB) Troubleshooting
Center Side Airbag (CSAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The center...
Driver Airbag (DAB) On Vehicle Inspection. Driver Airbag (DAB) Troubleshooting
Driver Airbag (DAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The driver airba...
See also:

Front Door Latch Assembly Repair Procedures
Removal 1. Remove the front door module. (Refer to Door (Front) - "Front Door Module") ...

Cowl Side Trim Repair Procedures
Removal and Installation 1. Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim") ...

Oil Temperature Sensor (E-Module) Removal
Removal ...

Copyright © www.ksmanual.com 2014-2026 - 0.0428