Kia Sorento: Oil Cooler Installation
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Lubrication System / Oil Cooler Installation
| 1. |
Apply a light coat of engine oil to the oil cooler packing surface (A),
and then install the oil cooler with fix bolt (B).
|
| 2. |
Apply a light coat of engine oil to the oil filter packing surface (A),
and then install the oil filter.
|
| 3. |
Connect the oil cooler coolant hoses (B).
|
| 4. |
Fill the radiator with coolant and check for leaks.
|
Oil Cooler Removal
1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap
to help drain the coolant faster.
2.
Disconnect the oil cooler coo ...
Oil Pan Removal
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the A/C compressor.
(Refer to Heating, Ve ...
See also:
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV termina ...
Removal
1.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
2.
Remove the battery and the battery tray.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026