Kia Sorento: Auto Defogging Actuator Description

The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mode actuator.

Mode Control Actuator Replacement

1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's side crash pad side cover. ...

Auto Defogging Actuator Inspection

1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defoggin ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

Special Service Tools
Tools (Number and name) Illustration Use 09431-45100 Oil seal installer Installation of transfer case oil seal. (Right side) ...

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") ...