Kia Sorento: Blind-Spot Collision-Avoidance Assist operation - Blind-Spot Collision-Avoidance Assist (BCA): (if equipped) - Driver assistance guideKia Sorento: Blind-Spot Collision-Avoidance Assist operation

Kia Sorento (MQ4, 2021-2026) Owner's Manual / Driver assistance guide / Blind-Spot Collision-Avoidance Assist (BCA): (if equipped) / Blind-Spot Collision-Avoidance Assist operation

Blind-Spot Collision-Avoidance Assist operates as follows:

Collision Warning (while driving)

Instrument cluster and mirror indicator alerts for the Collision Warning system on the Kia Sorento

The warning light on the instrument cluster, outside rearview mirror, and head-up display (if equipped) appear when a vehicle in either of the surrounding lanes is detected from the rear.

A vehicle is detected in the following conditions:

With vehicle detection in use, Collision Warning will alert you when you activate the turn signal to make a lane change while there is a car in your blind spot.

Collision Warning operates under the following conditions:

WARNING

TIP

Collision-Avoidance Assist (while departing)

Emergency Braking status notification displayed on the instrument panel of the Kia Sorento

(A) Emergency Braking

The warning light on the outside rearview mirror, head-up display (if equipped), an audible warning, and steering wheel vibration warn you of a collision. This function assists in braking control to prevent a collision with a vehicle approaching from your blind spot.

Collision-Avoidance Assist activates in the following conditions:

Drive carefully warning message shown on the Kia Sorento instrument cluster display

(A) Drive carefully

When the vehicle is stopped due to Emergency Braking, a warning message appears on the instrument cluster. For your safety, engage the brake pedal immediately and check the surroundings.

Brake control ends approximately 2 seconds after Emergency Braking stops your vehicle.

WARNING

WARNING

Brake control may not operate properly depending on the status of Electronic Stability Control (ESC).

There will only be a warning when:

See also:

Quarter Fixed Glass Installation
1. With a putt knife, scrape the old adhesive smooth to a thickness of about 2mm (0.08 in.) on the bonding surface around the entire quarter fixed glass flange. ...

Interior A
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Circuit Diagram
...

Copyright © www.ksmanual.com 2014-2026