Kia Sorento: Alternator Specification - Charging System - Engine Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Alternator Specification

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Electrical System / Charging System / Alternator Specification

Alternator
Item
Specification
Rated voltage
13.5V, 130A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C
Internal mode
-3.5 ± 2mV / °C

※ Regulator Setting Voltage (External mode)
Alternator Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage ...

Alternator Components
1. Overrun Alternator Pully (OAP) 2. Front bracket 3. Front bearing 4. Rotor 5. Rear bearing 6. Rear bracket 7. Through bolt 8. Regulator assembly 9. Regulator b ...

See also:

26 Brake Control Solenoid Valve(26/B_VFS)
26Brake control solenoid valve(26/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26Brake. ...

Heater & A/C Control Unit (DATC) Replacement
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia panel (A). ...

Warning lights
✽ NOTICE - Warning lights Make sure that all warning lights are OFF after starting the engine. If any light is still ON, this indicates a situation that needs attention. Air bag Warning Ligh ...

Copyright © www.ksmanual.com 2014-2024