Kia Sorento: Alternator Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Electrical System / Charging System / Alternator Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove the cable from alternator "B" terminal (C).
|
| 3. |
Remove the drive belt (A) after turning the drive belt tensioner
(B) counter clockwise.
|
| 4. |
Full out the through bolt and then remove the alternator (A).
|
Alternator Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target
...
Alternator Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical ...
See also:
Engine Mounting Removal and Installation
Roll road Bracket
1.
Remove the roll road bracket(A).
Tightening torque
Bolt (B) :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ...
Specifications
Item
Specification
Rated voltage
DC 3V
Temperature range
-4°F ~ 140°F (-20°C ~ +60°C)
RF Modulation method
FSK
...
Description
BSD is a system that uses two magnetic wave radar sensors attached on
the rear bumper to measure the distance from the following vehicles and provides
the sensing and (visual and auditory) al ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026