Kia Sorento: Door Mood Lamp Removal - Lighting System - Body Electrical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Door Mood Lamp Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body Electrical System / Lighting System / Door Mood Lamp Removal

1.
Disconnect the negative battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front door")
3.
Disconnect the door mood lamp connector (A).

4.
Remove the door mood lamp (A) after loosening the screws.

Overhead Console Lamp Installation
1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector. 2. Install the lens after tightening ...

Door Mood Lamp Installation
1. Install the door mood lamp and connector. 2. Install the front door trim. 3. Connect the negative battery te ...

See also:

Inspection
[Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied ...

Rear Hub - Carrier Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the rear axle carrier for cracks. ...

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Retainer ring 10. ...

Copyright В© www.ksmanual.com 2014-2023