Kia Sorento: Alternator Circuit Diagram

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Electrical System / Charging System / Alternator Circuit Diagram

â€¢	COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower)

â€¢

FR signal - The transistor activation signal inside the alternator monitors the voltage generated by the alternator to control the excitation current before it sends the FR signal to the ECM. (At certain RPM/electric loads, the FR duty can remain static. However, more often, the RPM, electric load, target voltage, etc. are always changing in the vehicle, so the FR must also change constantly)

â€¢	L signal - Turns on the battery warning lamp on the dashboard when the battery charging system malfunctions. (Conditions for turning on the lamp - overcharge, over discharge, a field coil blown inside the alternator)

â€¢	B+ terminal - The output voltage from the generator travels to the battery via the B+ terminal.

Alternator Components

1. Overrun Alternator Pully (OAP) 2. Front bracket 3. Front bearing 4. Rotor 5. Rear bearing 6. Rear bracket 7. Through bolt 8. Regulator assembly 9. Regulator b ...

Alternator Removal

1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...

Kia Sorento: Alternator Circuit Diagram

Alternator Components

Alternator Removal

See also:

Categories