Kia Sorento: Parking Brake Pedal Assembly Adjustment - Parking Brake System - Brake System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Parking Brake Pedal Assembly Adjustment

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Brake System / Parking Brake System / Parking Brake Pedal Assembly Adjustment

Parking Brake Pedal Stroke Adjustment
1.
Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables.
2.
Adjust the adjusting nut(A) for parking barke pedal stoke 8 ~ 9 notches when operating effort is 294N(30kgf, 66lbf)

  
1.
The parking brake adjustment must be carried out after adjusting the rear shoe.
2.
After adjusting parking brake, notice following matter.
1)
Must be free from clearance between adjusting nut and pin.
2)
Check securely that the brake is not dragging.
Parking Brake Pedal Assembly Installation
1. Install the holding clip (A, B) after fixing the parking brake cable. 2. Install the parking brake pedal, and then install the p ...

Parking Brake Cable Removal
Parking brake pedal Type 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lo ...

See also:

Installation
1. Install the horns after connecting the horn connectors. 2. Install the head lamp. (Refer to "Lighting system") ...

Speakers Replacement
Front Speaker 1. Remove the front door trim. (Refer to Body - "Front door") 2. Remove the front speaker (A) after removing ...

Input Speed Sensor Signal Waveform
...

Copyright В© www.ksmanual.com 2014-2024