1. |
Install the shoe hold down pin (A) and spring (B) by pressing
and rotating the spring.
|
2. |
Install the operating lever assembly (D) and the upper return
spring (C).
|
3. |
Install the adjuster assembly (B) and the lower return spring
(A).
|
4. |
Install the hub assembly.
(Refer to Drive shaft and axle - "Rear hub - carrier")
|
5. |
Install the parking brake cable (B), and then install the fixing
clip (A).
|
6. |
Install the rear brake disc, then adjust the rear brake shoe clearance.
|
7. |
Install the brake caliper assembly.
(Refer to Brake system - "Rear disc brake")
|
8. |
Install the tire and wheel, after installing the plug on the disc.
|
9. |
If the parking brake shoe or the brake disc are replaced a newly
one, perform the brake shoe bed-in procedure.
|
Special Service Tools
Tools
(Number and name)
Illustration
Use
09431-45100
Oil seal installer
Installation of transfer case oil seal.
(Right side)
...
Console Replacement
Floor Console Assembly Replacement
•
Pry the trim off using a plastic trim tool and apply ...
Fluid Component Location
1. ATF Injection hole(eyebolt)
2. Oil level plug
3. Oil drain plug
...