Kia Sorento: Parking Brake Assembly Removal
| 1. |
Raise the vehicle, and make sure it is securely supported.
|
| 2. |
Remove the rear tire and wheel.
|
| 3. |
Remove the rear brake caliper and Rear disc brake.
(Refer to "Rear disc brake removal")
|
| 4. |
Remove the parking brake cable (B), after removing the fixing
clip (A).
|
| 5. |
Remove the hub assembly.
(Refer to Driveshaft and axle - "Rear hub - carrier")
|
| 6. |
Remove the adjuster assembly (B) and the lower return spring (A).
|
| 7. |
Remove the upper return spring (C) operating lever assembly (D).
|
| 8. |
Remove the shoe hold down pin (A) and the spring (B) by pressing
and rotating the spring.
|
| 9. |
Remove the brake shoes (C).
|
Components and Components Location
Parking Brake Assembly InstallationHeater & A/C Control Unit (DATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel
(A).
...
4WD ECU Removal
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing
with the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
...
Rear Driveshaft Disassembly
•
Do not disassemble the BJ assembly.
•
...