Kia Sorento: Emergency Fastening Device (EFD) Removal
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Removal
| 1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
| 2. |
Remove the EFD cover pad (A).
|
| 3. |
Remove the seat belt after pushing the lock pin with a fiat-tip
screwdriver (B).
|
| 4. |
Remove the door scuff trim. (Refer to the Body group- Interior
trim)
|
| 5. |
Remove the center pillar trim. (Refer to the Body group- Interior
trim)
|
| 6. |
Disconnect the EFD connector (A).
|
| 7. |
Loosen the EFD mounting bolt (B) and remove the EFD.
|
Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on driver and pass ...
Emergency Fastening Device (EFD) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...
See also:
Battery Vehicle parasitic current inspection
1.
Turn the all electric devices OFF, and then turn the ignition
switch OFF.
2.
Close all doors except the engine hood, and then lock all d ...
Fuel Tank Air Filter Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
Power Mosfet (DATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025