Kia Sorento: TPMS Receiver Operation
|
1. |
General Function
| A. |
Auto learn takes place only once per Ignition cycle.
|
| B. |
On successful completion.
|
| C. |
Until Auto-learn completes, previously learned sensors
(together with their respective locations) are monitored for
under inflation / leak warnings.
|
| D. |
Spare tire inflation / DTC state is not displayed.
|
|
|
2. |
General Conditions to Learn New Sensors:
| A. |
Auto learning only functions when speed is more than 25
kph (approx. 15 mph).
|
| B. |
Receiver must determine that it is confident that sensor
is not temporary:
|
| 2) |
Uses confidence reduction of previously learned
sensors.
|
|
| C. |
Typical time at driving over 25 kph to learn a new sensor
is up to 10 minutes.
|
|
|
3. |
General Conditions to Un-Learn a sensor that is removed:
| A. |
It takes less than 10 minutes at 20~30kph.
|
| B. |
Confidence reduction is dependant on vehicle speed and
the number of sensors known to the receiver.
|
|
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
See also:
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...
Circuit Diagram
Connector Pin Information
No.
Wire harness connector
Panorama motor
Blind motor
1
Ground 1 ...
Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
TPMS Receiver Description
TPMS Receiver Replacement