1. |
Turn ignition switch OFF.
|
2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Disconnect the solenoid valve connector (A).
|
4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
5. |
Check that the resistance is within the specification.
|
Positive Crankcase Ventilation (PCV) Valve Installation
1.
Install in the reverse order of removal.
PCV Valve installation:
1.9 ~ 2.8 N.m (0.19 ~ 0.29 kgf.m, 1.4 ~ 2.1 lb-ft)
...
Power Tailgate Latch Inspection
Power Tailgate Inspection With GDS
1.
Check the power Tailgate module input/output value by using the
GDS. If the operation of power Tailgate module is abnormal, replac ...
Balance Shaft & Oil Pump Removal
BSM (Balance Shaft Module) Chain System
1.
Remove the timing chain.
(Refer to Timing System in this group)
2.
Install a stopper pin (A) ...