Kia Sorento: Accelerator Pedal Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation nuts (C), the bolt (B) and then remove the accelerator pedal module.

Filler-Neck Assembly Installation

1. Install in the reverse order of removal. Filler-neck assembly bracket installation nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ ...

Accelerator Pedal Installation

1. Install in the reverse order of removal. Accelerator pedal module installation nut: 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18 ...

See also:

Power Seat Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Front Impact Sensor (FIS) Installation
â€¢ Do not turn the ignition switch ON and do not contact the battery cable while replac ...

Inspection
Lighting Switch Inspection 1. With the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is no ...

Categories

Copyright © www.ksmanual.com 2014-2025