Kia Sorento: Starter Disassembly
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Electrical System / Starting System / Starter Disassembly
| 1. |
Disconnect the M-terminal (A) on the magnet switch assembly (B).
|
| 2. |
After loosening the screws (A), detach the magnet switch assembly
(B).
|
| 3. |
Loosen the through bolts (A).
|
| 4. |
Remove the brush holder assembly (A), yoke (B) and armature (C).
|
| 5. |
Remove the lever plate (B) and lever packing (A).
|
| 6. |
Remove the packing (A) and shield (B).
|
| 7. |
Disconnect the planet gear (A).
|
| 8. |
Disconnect the planet shaft assembly (or reducer assembly) (A)
and lever (B).
|
| 9. |
Press the stopper (A) using a socket (B).
|
| 10. |
After removing the stop ring (A) using stop ring pliers (B).
|
| 11. |
Disconnect the stopper (A), overrunning clutch (B), internal gear
(C), planet shaft (D) and/or gasket sheet (E).
|
| 12. |
Reassembly is the reverse of disassembly.
|
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Starter Reassembly
1.
Reassemble in the reverse order of disassembly.
...
See also:
Front Disc Brake Replacement
Front brake pads
1.
Loosen the guide rod bolt (B) and then remove caliper body (A).
2.
Replace pad shim (D), pad retainers (C) and b ...
Special Tools
Tool (Number and name)
Illustration
Use
09793-21000
Door hinge adjusting wrench
Adjustment, removal and installationof the door hinge
...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025