[On vehicle inspection] |
1. |
Accelerate the engine to about 3,000 rpm 3 times or more.
|
2. |
Remove the spark plug.
|
3. |
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as
below.
|
[Component Inspection] |
1. |
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
|
2. |
Check the electrode. Measure the insulation resistance with an
ohmmeter.
If the resistance is less than the specified value, adjust the
electrode gap.
|
3. |
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.
|
Rear Air Conditioner Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recover/recycling/charging station.
3.
...
Illuminated ignition switch (if equipped)
Whenever a front door is opened, the ignition switch will illuminate for your
convenience, provided the ignition switch is not in the ON position. The light will
go off immediately when the igniti ...
CVVT & Camshaft Components
1. Camshaft bearing cap
2. Camshaft front bearing cap
3. Exhaust camshaft
4. Intake camshaft
5. Exhaust CVVT assembly
6. Intake CVVT assembly
7. Exhaust camshaft upper ...