Kia Optima Manuals

Kia Sorento: Oil Pan Installation - Lubrication System - Engine Mechanical System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Oil Pan Installation

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Mechanical System / Lubrication System / Oil Pan Installation

1.
Install the oil pan.
(1)
Using a gasket scraper, remove all the old sealant material from the gasket surfaces.
(2)
Before assembling the oil pan, liquid sealant Loctite 5900H, Threebond 1217H or equivalent should be applied on oil pan. The part must be assembled within 5 minutes after sealant was applied.
Bead width : 3.0 mm (0.12 in.)

  
•
When applying sealant gasket, sealant must not be protruded into the inside of oil pan.
•
To prevent leakage of oil, apply sealant gasket on the inner threads of the bolt holes.
(3)
Install the oil pan (A). Uniformly tighten the bolts in several passes.
Tightening torque
Bolts B (M9) :
30.4 ~ 34.3 N.m (3.1 ~ 3.5 kgf.m, 22.4 ~ 25.3 lb-ft)
Bolts C (M6) :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

  
After assembly, wait at least 30 minutes before filling the engine with oil.
  
Always use a new drain plug gasket.
2.
Install the A/C compressor bracket (A).
Tightening torque :
19.6 ~ 23.5 N.m (2.0 ~ 2.4 kgf.m, 14.5 ~ 17.4 lb-ft)

3.
Install the A/C compressor lower bolts.
(Refer to Heating, Ventilation, Air Conditioning - "Compressor")
4.
Refill engine with engine oil.
Oil Pan Removal
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the A/C compressor. (Refer to Heating, Ve ...

Balance Shaft & Oil Pump Components
1. Balance shaft & oil pump assembly 2. Balance shaft chain tensioner 3. Balance shaft chain 4. Balance shaft chain sprocket 5. Balance shaft chain guide 6. Balance shaft ...

See also:

ATF Warmer Removal
1. Drain the coolant. (Refer to Engine Mechanical System - "Coolant") 2. Remove the air cleaner assembly and air duct. ...

Tire Wear
1. Measure the tread depth of the tires. Tread depth [limit] : 1.6 mm (0.0630 in.) 2. If the re ...

Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

Categories

Copyright www.ksmanual.com 2014-2025