1. |
Measure the tread depth of the tires.
|
2. |
If the remaining tread depth (A) is less than the limit, replace
the tire.
|
Checking For Pull And Wander |
1. |
Rotate the front right and front left tires, and perform a road
test in order to confirm vehicle stability.
|
2. |
If the steering pulls to the opposite side, rotate the front and
rear tires, and perform a road test again.
|
3. |
If the steering continues to pull to one side, rotate the front
right and left tires again, and perform a road test.
|
4. |
If the steering continues to pull to the opposite side, replace
the front wheels with new ones.
|
Installation
•
Install the component with the specified torques.
•
...
Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
1.
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinde ...
Description
The Electronic Throttle Control (ETC) System consists of a throttle body
with an integrated control motor and throttle position sensor (TPS). Instead
of the traditional throttle cable, an Acc ...