Kia Sorento: Oil Cooler Installation - Lubrication System - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Oil Cooler Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Lubrication System / Oil Cooler Installation

1.
Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B).

Tightening torque:
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

  
Fix position of oil cooler stopper(A) where oil cooler resists on ladder frame stopper (B).

2.
Apply a light coat of engine oil to the oil filter packing surface (A), and then install the oil filter.

Tightening torque:
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

3.
Connect the oil cooler coolant hoses (B).

4.
Fill the radiator with coolant and check for leaks.
Oil Cooler Removal
1. Loosen the drain plug, and drain the coolant. Remove the radiator cap to help drain the coolant faster. 2. Disconnect the oil cooler coo ...

Oil Pan Removal
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the A/C compressor. (Refer to Heating, Ve ...

See also:

Brake Line Installation
1. Installation is the reverse of removal.    Use a new washer (A) whenever ...

Spark Plug Description
A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture therein by mean ...

Front Wheel Transfer Assembly Components Location
1. Under cover 2. Transaxle Assembly 3. Transfer assembly 4. Propeller shaft 5. Coupling assembly 1. Under cover 2. Transaxle Assembly 3 ...

Copyright В© www.ksmanual.com 2014-2024