Kia Sorento: Removal - Multifunction switch - Body Electrical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body Electrical System / Multifunction switch / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing 3 screws.

3.
Disconnect the light switch connector (A) and the wiper switch connector (B).

4.
Remove the wiper switch (A) by pushing the lock pin (B).
  
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

5.
Remove the steering wheel.
(Refer to Steering System - "Steering column and shaft")
6.
Remove the clock spring.
(Refer to Restraint - "Airbag module")
7.
Loosen the screws from the multifunction switch assembly (A).

Component
...

Installation
1. Install the multifunction switch. 2. Install the clock spring and steering wheel. 3. Install the steering co ...

See also:

Seat Heater Installation
1. Install the driver / assist seat heater. (Refer to Body - "Front seat") 2. Install the rear seat LH heater and RH heater. ...

Auto Defogging Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the auto defogging sensor cover (A). 3. Disconnect t ...

Installation
1. Install the multifunction switch. 2. Install the clock spring and steering wheel. 3. Install the steering co ...

Copyright В© www.ksmanual.com 2014-2023