1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
4. |
If they are abnormal, replace the washer motor.
[Front & Rear washer]
1. Windshield washer (+)
2. Ground
3. Rear washer (+)
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Drain the washer fluid less than 650 cc.
|
3. |
Check for continuity between the No. 1 and No.2 terminal in each
float position.
There should be continuity when the float is down.
There should be no continuity when the float is up.
|
4. |
If the continuity is not as specified, replace the washer fluid
level switch
|
Tire and wheels
Tire care
For proper maintenance, safety, and maximum fuel economy, you must always maintain
recommended tire inflation pressures and stay within the load limits and weight
distribution recommended ...
Interior Trim Components
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Front door scuff trim
5. Rear door scuff trim
6. Cowlside trim
7. Rear pillar trim
8 ...
Dynamic Damper Components
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
...