Kia Sorento: Immobilizer Control Unit Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
|
| 3. |
Disconnect the 5P connector of the SMARTRA unit and then remove
the SMARTRA unit (A) after loosening a bolt.
|
Diagnosis Of Immobilizer Faults
-
Communication between the ECM and the SMARTRA.
-
Function of the SMARTRA and the transponder.
-
Data (stored in the EC ...
Immobilizer Control Unit Installation
1.
Install the immobilizer control unit after connecting the unit
connector.
2.
Install the crash pad lower panel.
...
See also:
Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset
/ relearned according to the following procedure.
1.
Check DTC(s) and clear if exist.
...
Engine Mounting Removal and Installation
Roll road Bracket
1.
Remove the roll road bracket(A).
Tightening torque
Bolt (B) :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ...
Heater Core Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026