1. |
Remove the connector (A) from the wiper motor.
|
2. |
Attach the positive (+) lead from the battery to terminal 2 and
the negative (-) lead to terminal 5.
|
3. |
Check that the motor operates at low or high speed as below table.
|
Engine Control Module (ECM) Adjustment
•
After replacing the ECM of the vehicle with the immobilizer, the
following procedure must be performed.
1)
[If installing a used ECM]
...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
Spark Plug Specification
Item
Specification
Type
FXU16HR11
Gap
1.0 ~1.1 mm
(0.0394 ~ 0.0433 in.)
...