1. |
Disconnect the IMS control switch connector.
|
2. |
With the power IMS control switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the IMS control switch.
|
Front Impact Sensor (FIS) Removal
•
Removal of the airbag must be performed according to the
precautions/ procedures des ...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross Veh ...
ESC OFF Switch Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer the Body - & ...