Kia Sorento: 12 V Lithium Auxiliary Battery Description and Operation - Charging System - Body Electrical SystemKia Sorento: 12 V Lithium Auxiliary Battery Description and Operation

Kia Sorento (MQ4, 2021-2026) Service Manual / Body Electrical System / Charging System / 12 V Lithium Auxiliary Battery Description and Operation

Description and Operation Principle
•
The P-LBM (Parking Lithium Battery Module) is an additional 12 V auxiliary battery, separate from the main 12 V battery, designed to provide a stable power supply for vehicle functions while parked.
•
This auxiliary battery system supplies power through a dedicated output line to support functions that operate when the ignition is OFF—such as the built-in camera, afterblow, Kia Connect (CCS), and OTA updates—while the vehicle is parked.
•
The P-LBM uses auxiliary batteries with two capacity options—28.8 Ah or 19.2 Ah—depending on whether the vehicle is equipped with a built-in camera.
•
P-LBM outputs power according to a discharge request signal and supplies power into the vehicle through PDC (the Power Domain Controller).
•
When the SOC (State of Charge) of 12 V main battery is low, P-LBM outputs maximum power and charges the main battery.
•
P-LBM receives a power output request signal from built-in cam unit and supplies power into built-in cam.
•
The system starts supplying power through the ACU (Airbag Control Unit) output circuit when IG2 is ON, and continues for up to 5 minutes after the ignition is turned OFF before stopping.
P-LBM Troubleshooting

Body Electrical System — Charging System / 12 V Lithium Auxiliary Battery / Description and Operation / Description and Operation Principle illustration

P-LBM Image and Connector PIN-MAP
IMAGE
PIN NUMBER
PIN NAME
PIN DESCRIPTION

Body Electrical System — Charging System / 12 V Lithium Auxiliary Battery / Description and Operation / Description and Operation Principle illustration

1
B+
Power(+)
2
Ground
Ground
3
IG2
Power(+)
4
Not Connect
-
5
L-CAN 1 High
LOCAL_CAN_H
6
L-CAN 1 Low
LOCAL_CAN_L
7
LIN
LIN(Built-in Cam)
8
Other Unit (+)
OUTPUT(Built-in Cam)
9
Other Unit (+)
OUTPUT(ACU)
10
Not Connect
-
11
Not Connect
-
12
Not Connect
-

Charging System
...
12 V Lithium Auxiliary Battery Removal and Installation
Removal 1. Remove the front seat assembly. [Passenger's side] (Refer to Body - "Front Seat Assembly") ...
See also:

Steering Gear Rack, Linkage and Boots Repair procedures
Repair procedures Steering Wheel Play Inspection 1. Align the steering wheel straight. ...

Rear Seat Cushion Cover Repair Procedures
Removal and Installation [2nd Seat Cushion Cover] [5/7P] [LH] 1. Remove the 2nd seat assembly [LH]. ...

Floor mat anchors: (if equipped). Luggage net holder
Floor mat anchors: (if equipped) When installing a floor mat on the front floor carpe ...

Copyright © www.ksmanual.com 2014-2026 - 0.059