Kia Sorento: Windshield Deicer Switch Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Windshield Deicer / Windshield Deicer Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
|
| 3. |
Disconnect the connectors and cables (A) from center fascia panel.
|
| 4. |
Remove the heater control unit (A) with the windshield deicer
switch.
|
Inspection
1.
Remove the cowl top cover.
(Refer to the wiper)
2.
Disconnect the windshield deicer connector (A) from the wiper
motor linkage.
...
Windshield Deicer Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...
See also:
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a bulb check.
The l ...
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop ...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the e ...
Copyright В© www.ksmanual.com 2014-2024