Kia Sorento: Thermostat Inspection - Cooling System - Engine Mechanical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Thermostat Inspection

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Mechanical System / Cooling System / Thermostat Inspection

1.
Immerse the thermostat in water and gradually heat the water.

2.
Check the valve opening temperature.

Valve opening temperature: 82°C (177°F)
Full opening temperature: 95°C (205°F)

If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.

Valve lift : 8 mm (0.3 in) or more at 95°C (205°F)

If the valve lift is not as specified, replace the thermostat.
Thermostat Removal and Installation
   Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the ther ...

Thermostat Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting bolts ...

See also:

Direct Electro Hydraulic Actuator Coupling Operation
Electronic Coupling [Inactive] [Active] Operation Order 1. 4WD ECU receives CAN signals from the vehicle's sensors. ...

Transmitter Code Registration (Using GDS)
1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. ...

Heater Unit Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. ...

Copyright © www.ksmanual.com 2014-2019