Kia Sorento: Pressure Sensor Removal - Coupling Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2020 Service ManualKia Sorento: Pressure Sensor Removal

Second Generation XM (2011-2020) / Kia Sorento XM 2011-2020 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Pressure Sensor Removal

1.
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling")
2.
Remove the extensioncable (A).

3.
Remove the pressure sensor (A) with 24mm socket.
  
Х
Keep going horizontal state to prevent leaks during remove the pressure sensor.

Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2 lb-ft)

Pressure Sensor Inspection
   If you have trouble code related to the pressure sensor check pressure sensor according to the inspection process. ...

Pressure Sensor Installation
   Х Check the cleanliness of the pressure sensor before installation. ...

See also:

Tilting the sunroof
Before opening or closing the sunroof, open the roller blind (refer to the following page for instructions on how to use the roller blind). To open the sunroof, push the sunroof control lever upwa ...

Starter Removal
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

Head Lamps Component (2)
1. Head lamp assembly 2. Head lamp high beam bulb 3. Head lamp low beam bulb (HID & ignitor) 4. Dust cap 5. Turn signal lamp socket & bulb ...

Copyright © www.ksmanual.com 2014-2020