Kia Sorento: Pressure Sensor Installation - Coupling Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Pressure Sensor Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Pressure Sensor Installation

  
Х
Check the cleanliness of the pressure sensor before installation.
Х
Check the pressure sensor O-ring (A).

1.
Install in the reverse order of removal.
Pressure Sensor Removal
1. Remove the coupling assembly. (Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling") 2. Remove th ...

Driveshaft and axle
...

See also:

Specifications
Direct control VFS[UD/B] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0) Current value(mA) ...

Intake Manifold Removal and Installation
1. Disconnect the battery negative terminal. 2. Remove the air cleaner assembly. (Refer to Intake And Exhaust System - "Air Cleaner ...

Rear Glass Defogger Switch Installation
1. Install the heater control unit. 2. Install the center fascia panel. ...

Copyright © www.ksmanual.com 2014-2019