Kia Sorento: Power Tailgate Latch Removal
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Power Tailgate Module / Power Tailgate Latch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
After loosening the mounting screws, then remove the tailgate
trim (A).
(Refer to the Body - "Tailgate")
|
| 3. |
Remove the tail gate latch assembly (A) after loosening the mounting
bolts.
|
| 4. |
Loosen the PCU (Power Closing Unit) mounting nuts.
|
| 5. |
Disconnect the power tailgate latch connector (A) and PCU connector
(B).
|
| 6. |
Remove the power tailgate latch & PCU assembly (A).
|
Power Tailgate Unit Installation
1.
Install the power tailgate unit.
2.
Install the rear left luggage side trim.
3.
Connect the negative (-) bat ...
Power Tailgate Latch Installation
1.
Install the power tailgate latch & PCU assembly.
2.
Install the tailgate trim.
3.
Connect the negative ( ...
See also:
Input Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
AUX(Auxiliary) Jack Circuit Diagram
...
Interior A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025