Kia Sorento: Power Tailgate Latch Installation - Power Tailgate Module - Body Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Power Tailgate Latch Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Body Electrical System / Power Tailgate Module / Power Tailgate Latch Installation

1.
Install the power tailgate latch & PCU assembly.
2.
Install the tailgate trim.
3.
Connect the negative (-) battery terminal.
Power Tailgate Latch Removal
1. Disconnect the negative (-) battery terminal. 2. After loosening the mounting screws, then remove the tailgate trim (A). (Refer ...

Power Tailgate Latch Inspection
Power Tailgate Inspection With GDS 1. Check the power Tailgate module input/output value by using the GDS. If the operation of power Tailgate module is abnormal, replac ...

See also:

Rear Washer Motor Inspection
1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    ...

Console Components
[M/T] 1. Floor console assembly 2. Console upper cover 3. Console side cover [LH] 4. Console side cover [RH] 5. Rear console cover 6. Floor console mounting ...

Rear Differential Carrier Reassembly
Pinion drive gear height adjustment Adjust the height of the drive pinion in the following order. 1. Below are the special tools to measure the pinion height ...

Copyright © www.ksmanual.com 2014-2019