Kia Sorento: Parking Brake Pedal Assembly Removal - Parking Brake System - Brake System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Parking Brake Pedal Assembly Removal

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Brake System / Parking Brake System / Parking Brake Pedal Assembly Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the junction box.
(Refer to Body Electrical System - "Relay Box(Passenger Compartment"))
4.
Disconnect the parking brake switch connector.
5.
Remove the parking brake cable mounting nuts (A).

6.
Remove the parking brake pedal mounting bolts (A) and nut (B).

7.
Remove the parking brake cable the fixing clip (A, B), and then remove the parking brake pedal.

Parking Brake Lever Assembly Adjustment
Parking Brake Lever Stroke Adjustment 1. Remove the floor console. (Refer to Body - "Floor console") 2. Apply the brake p ...

Parking Brake Pedal Assembly Installation
1. Install the holding clip (A, B) after fixing the parking brake cable. 2. Install the parking brake pedal, and then install the p ...

See also:

Specification
Pressure [kPa (kgf/cm², in H2O) Output Voltage (V) -3.75 (-0.038, -15.05) 4.5 0 1.5 +1.25 (0.013, 5.02) 0.5 ...

Compressor Oil Specification
1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. ...

Engine compartment
1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch fluid reservoir 4. Air cleaner 5. Fuse box 6. Negative battery terminal 7. Positive battery terminal 8. Radiator cap 9. E ...

Copyright © www.ksmanual.com 2014-2019