Kia Optima Manuals

Kia Sorento: Oil Pan Removal - Lubrication System - Engine Mechanical System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Oil Pan Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Mechanical System / Lubrication System / Oil Pan Removal

1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the A/C compressor.
(Refer to Heating, Ventilation, Air Conditioning - "Compressor")
3.
Remove the A/C compressor bracket (A).

4.
Drain the engine oil.
5.
Remove the oil pan (A). Insert the blade of SST (09215-3C000) between the ladder frame and oil pan. Cut off applied sealer and remove the lower oil pan.

  
•
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow.
•
After tapping the SST with a plastic hammer along the direction of arrow around more than 2/3 edge of the oil pan, remove it from the ladder frame.
•
Do not turn over the SST abruptly without tapping. It be result in damage of the SST.
Oil Cooler Installation
1. Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B). Tightening torque: ...

Oil Pan Installation
1. Install the oil pan. (1) Using a gasket scraper, remove all the old sealant material from the gasket surfaces. ...

See also:

Heater Core Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

Curtain Airbag (CAB) Module Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

Categories

Copyright www.ksmanual.com 2014-2025