Kia Sorento: Overhead Console Lamp Inspection

Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

Room Lamp Installation

1. Install the room lamp assembly after connecting the lamp connector. 2. Install the lamp lens after assembling the bulb. ...

Overhead Console Lamp Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the mounting screws (2EA). And then remove the overhead console (A). ...

See also:

Rear Driveshaft Removal and Installation
1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Starter Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

4WD ECU Installation
1. Install in the reverse order of removal. 2. Prior to installing a new ECU, upload the original ECU’s clutch learing to the replacement E ...