Kia Sorento: Measurement Method
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body (Interior and Exterior) / Body Dimensions / Measurement Method
| Projected Dimensions |
| 1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
| 2. |
Measure by first adjusting both probes to the same length (A=A').
|
| Measurement Point |
| 1. |
Measurements should be taken at the hole center.
|
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Front Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
See also:
Rear Driveshaft Components
1. Tone wheel
2. BJ joint
3. BJ boot
4. BJ boot big part band
5. BJ boot small part band
6. Shaft
7. TJ boot small part band
8. TJ boot big part band
9. TJ boot
...
Air bag
(1) Driver’s front air bag
(2) Passenger’s front air bag
(3) Side air bag
(4) Curtain air bag
WARNING
Even in vehicles with air bags, you and your passengers must always wear the
safety be ...
Description
The SMART KEY system is a system that allows the user to access and operate
a vehicle in a very convenient way. To access the vehicle, no traditional key
or remote control unit is needed.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026