Kia Sorento: Ignition Coil Removal - Ignition System - Engine Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Ignition Coil Removal

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Electrical System / Ignition System / Ignition Coil Removal

1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).

  
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

4.
Remove the ignition coil (A).

Ignition Coil Circuit Diagram
...

Ignition Coil Installation
1. Install in the reverse order of removal. Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft) ...

See also:

Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop ...

Heater Core Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

Fuel Pump Removal
1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") ...

Copyright © www.ksmanual.com 2014-2019