Kia Sorento: Antenna Inspection
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Audio / Antenna Inspection
Antenna Cable
| 1. |
Remove the antenna jack from the audio unit and antenna.
|
| 2. |
Check for continuity between the center poles of antenna cable.
|
| 3. |
Check for continuity between the outer poles of antenna cable.
There should be continuity.
|
| 4. |
If there is no continuity, replace the antenna cable.
|
| 5. |
Check for continuity between the center pole (A) and outer pole
(B) of antenna cable. There should be no continuity.
|
| 6. |
If there is continuity, replace the antenna cable.
|
Speakers Installation
Front speaker
1.
Install the speaker to the speaker mounting hole in the door in-panel.
2.
Reconnect the speaker connector.
Rea ...
Antenna Removal
1.
Remove the rear roof trim.
(Refer to Body - "Roof trim")
2.
Disconnect the power cable (A).
3. ...
See also:
Auto Defogging Sensor Description
The auto defogging sensor is installed on the front window glass. The
sensor judges and sends signal if moisture occurs to blow out wind for defogging.
The air conditioner control module rece ...
Front Wiper Motor Installation
1.
Install the wiper motor.
2.
Install the crank arm.
Torque :
12.7-17.6Nm (1.3-1.8, kgf.m, 9.4-13.0 lbf. ...
ICM Relay Box Inspection
Rear Wiper Motor relay
Check for continuity between the terminals.
1.
There should be continuity between the No.1 and No.3 terminals
when power and ground are conne ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025