Kia Sorento: Alternator Reassembly - Charging System - Engine Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Alternator Reassembly

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Electrical System / Charging System / Alternator Reassembly

1.
Reassemble in the reverse order of disassembly.
  
When reassembling OAD pulley, replace with new OAD cap.
Alternator Disassembly
1. Remove the alternator cover (A) using a screw driver after loosening the nuts (B). 2. Remove the slip ring guide (A) and then lo ...

Alternator Inspection
[Rotor] 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the slip ...

See also:

Relay Box (Passenger Compartment) Installation
1. Install IPM(Intelligent intergrated Platform Module). 2. Connect the IPM connector. 3. Install the crash pad ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS)
Overdrive clutch control solenoid valve(OD/C) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...

Blind Spot Detection Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") ...

Copyright © www.ksmanual.com 2014-2019