Kia Sorento: Side Body C
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front side member tooling hole (Ø8.2) |
Fender apron upper panel tooling hole (Ø8) |
Front door upper hinge mounting hole (Ø13) |
|
|
|
|
| Front door lower hinge mounting hole (Ø13) |
Fender panel mounting hole (Ø6.6) |
Side outer panel notch |
|
|
|
|
| Side outer panel notch |
Side outer panel notch |
Front door switch mounting hole (Ø10) |
|
|
|
|
| Rear door upper hinge mounting hole (Ø13) |
Rear door lower hinge mounting hole (Ø13) |
Side outer panel notch |
|
|
|
|
| Side outer panel notch |
Quarter fixed glass mounting hole (Ø6) |
Rear door switch mounting hole (Ø10) |
|
|
|
|
| Side sill moulding mounting hole (12X12) |
Quarter fixed glass mounting notch |
Rear bumper mounting hole (Ø12) |
Side Body B
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Interior A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
See also:
Flat tire
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
(4) S ...
Blower Resistor Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025