Kia Sorento: Measurement Method
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body (Interior and Exterior) / Body Dimensions / Measurement Method
| Projected Dimensions |
| 1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
| 2. |
Measure by first adjusting both probes to the same length (A=A').
|
| Measurement Point |
| 1. |
Measurements should be taken at the hole center.
|
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Front Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
See also:
Catalytic Converter Removal
1.
Remove the exhaust manifold.
(Refer to Engine Mechanical System - "Exhaust Manifold")
...
Rear wheel alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...
Front Wheel Transfer Assembly Installation
1.
Install in the reverse order of removal.
1.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026