Kia Sorento: Side Airbag (SAB) Module Installation
|
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
| •
|
Do not open the lid of the side airbag cover.
|
| •
|
Make sure that the airbag assembly cover is installed
properly. Improper installation may prevent the proper deployment.
|
|
|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
|
3. |
Install the new seat back assembly. (Refer to the Body group-
Seat)
|
|
4. |
Install the front seat assembly. (Refer to the Body group- Seat)
|
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
|
6. |
Reconnect the battery negative cable.
|
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain airbag by us ...
See also:
Rear Glass Defogger Printed Heater Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure on th ...
Removal
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fr ...
Driver position memory system (if equipped, for power seat)
A driver position memory system is provided to store and recall the driver seat
and outside rearview mirror position with a simple button operation.
By saving the desired position into the system ...