Kia Optima Manuals

Kia Sorento: Driver Airbag (DAB) Module and Clock Spring Removal - Airbag Module - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Driver Airbag (DAB) Module and Clock Spring Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring Removal

1.
Set the front tires straight-ahead before removing the steering wheel.
  
If the steering wheel and the front tires are not set straight ahead together, it affects the number of circulation of steering wheel and the cable inside the clock spring is possible to be damaged.
2.
Disconnect the battery negative cable.
  
After disconnecting the battery negative cable, wait for at least thirty seconds.
3.
Release the connector locking pin, then disconnect the driver airbag module connector(B).
  
The removed airbag module should be stored in aclean, dry place with the pad cover face up.
4.
Remove the steering wheel and steering wheel column shroud. (Refer to the Steering System group- Steering Column and Shaft)
5.
Disconnect the clock spring and horn connector, then remove the clock spring.
Driver Airbag (DAB) Module and Clock Spring Components
1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...

Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one.    ...

See also:

Rear Wiper Motor Installation
1. Install the rear wiper motor assembly. Tightening torque Nut : 7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft) ...

SS-A Solenoid Valve(ON/OFF)
SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Smart key unit Circuit Diagtam
...

Categories

Copyright www.ksmanual.com 2014-2026